Professional Amplifiers for PA Systems
Power output: 320 watts per channel into 8Ω (stereo), 965W into 8Ω (mono) Frequency response: 20Hz to 20kHz Total harmonic distortion: 0.05% Gain: 26 dB Input sensitivity: 1.4V Signal to noise ratio: 100dB Speaker load impedance: 4Ω to 16Ω Dimensions: 483 x 89 x 406mm Weight: 14.5kg Year: 1992
This amplifier has inputs for both balanced XLR and unbalanced 6.35mm (1/4 inch) jack connections. The dual connection system allows connection to a wide range of equipment. If you are running longer cables the use of the balanced connections will allow you to significantly reduce the chances of the signal quality being affected by external electrical noise.
From the makers of some of the world’s most legendary guitars comes the Fender Mustang I V.2 guitar modelling combo amplifier. The Mustang gives you robust amp modelling and build in a slick, vinyl-covered package that can be taken with you anywhere without compromising on power
Description The DSP1100P offers 2 feedback suppression modes: a "single shot" mode where once set, filters remain on a fixed frequency until reset, and an "auto mode" where up to twelve filters are assigned and released from changing problem frequencies. The first is best for stage situations where mics are stationary.
tereo/parallel/bridge-mono modeUser selectable inputsensitivity - 0.775V and 1.4VRCA and XLR inputs; Speakon® and binding post outputsTwo level controls, power switch, power LED, and six LEDs which indicate signal presence, clip and fault for each channel4-ohm stereo (per channel) 1350W8-ohm stereo (per channel) 1000W8-ohm bridged 2700W